Toyota Celica Forum banner

1993 Celica GT Convertible – Sputtering/Low Idle Issue

182 views 12 replies 3 participants last post by  93celi.yota  
#1 · (Edited)
Aside from the fuel sending unit, I’m now dealing with another issue. On my way to work, the car began sputtering, the accelerator pedal and brake pedal felt soft, and the check engine light came on. The CEL goes away if I let off the gas. I also noticed a strong exhaust fume smell, and the idle drops to around 500 RPM.
I already checked for vacuum leaks but didn’t find anything obvious — not sure if I need to recheck all the lines. Has anyone run into this before or know what else I should inspect? Since it did it again when on my way home. Could it be because it rained really hard the night before and got water? If it does it again tomorrow i’ll take a video, I couldn’t take one today since i was on the busy interstate.
 
Discussion starter · #5 ·
I got 31 (Volume air flow (VAF)sensor circuit) 41 (throttle position (TP) sensor circuit) and 42 vehicle speed sensor. Parts at the dealership is having trouble finding the VAF which is now discontinued.
 
Discussion starter · #7 ·
i am not able to perform electrical since i’m not certified and don’t know how to. I was going to put my vehicle in service at the toyota dealership that i work at but one tech knows their way around the celica. Just the downside he’s always busy with warranty work and big jobs
 
Discussion starter · #9 ·
i am not able to perform electrical since i’m not certified and don’t know how to. I was going to put my vehicle in service at the toyota dealership that i work at but one tech knows their way around the celica. Just the downside he’s always busy with warranty work and big jobs
On your own personal vehicle, you don't need a certification. But you would need to be certified to fix other people's vehicles at a service shop. I'm not sure how to help you if you can't do basic diagnosis. I can send you the diagnostic pages for two of those 3 codes you have. If this were my car, I would remove the ECU and open it up to see if the circuit board is pristine or if it has evidence of something that burned up on the board or if it has leaking capacitors. ECU failures were fairly common on these early 1990's Toyota's.
Either way i’ll need to work on it myself since it is my only source of transportation due to my honda civic’s transmission blowing itself up since it was a 7th gen auto. It shouldn’t be too hard and yet it does it occasionally like today but it sorted itself out.
 
Discussion starter · #11 ·
Either way i’ll need to work on it myself since it is my only source of transportation due to my honda civic’s transmission blowing itself up since it was a 7th gen auto. It shouldn’t be too hard and yet it does it occasionally like today but it sorted itself out.
Well, let us know what you need for help so this forum can try to assist!
Definitely! Just hopefully it goes smoothly
 
Discussion starter · #13 ·
So after testing the sensors the tps was faulty, and the map sensor was going out due to some faulty wires. Ended up replacing the tps and cleaned the map sensor and had a friend help me replace some wires(thank god he knows what he’s doing). I did get a new map sensor luckily by a friend for cheap. Had the ecu cycle a bit yesterday and today and will say i have seen improvements and haven’t had the rpms drop like crazy or have the engine sputter like how it was recently.


I’m not certain if this fixed it, and will do more testing and driving to be positive this solved it.