Toyota Celica Forum banner
1 - 5 of 5 Posts

·
Super Moderator
Joined
·
422 Posts
Discussion Starter · #1 ·
Had my '91 GT for two years now with a bad transmission. Today I found out that the previous owner for what ever reason swapped the original trans for another but it wasn't the right one. The VIN did not match. Had trouble with that tranny slipping, shuddering etc since day one. Local shops would not touch a 31 year old "foreign" transmission. The ones that would look at it had prices ranges from $1740 to $2500 with no guarantee. Actually found two boneyard '91 Celica's in my area with "A" rated used transaxles with warranties. Ones that actually match the car.
NOW I need some help. Since I'll be doing the swap in my garage I'll need to raise the front up about 24" to give me room to put a floor jack under the unit. Has anyone done this and how would I get it up that high and where would be the best place to support it?
The shop manual give all the components but will need a step by step procedure on where to start.
Any suggestions?
 

·
Super Moderator
Joined
·
422 Posts
Discussion Starter · #3 ·
Thinking of taking the tranny to a local shop and have them do the install. If I was 50 years younger I'd do it. Just don't have the strength anymore. (77) :eek:
 

·
Super Moderator
Joined
·
422 Posts
Discussion Starter · #4 ·
Good news is My local mechanic is an old Toyota employee and will do the job at his shop. He's done the swap before. Was amazed that I had found two '91 Celicas locally. I'm keeping them a secret :cautious:
 

·
Super Moderator
Joined
·
422 Posts
Discussion Starter · #5 ·
Got my lil' red back today from the tranny swap. Not only did I loose reverse but after driving now I'm finding 4th gear and no shudders. Amazing.Boneyard replacement had 149k and the mechanic said the pan and magnets were reasonably clean with nothing noticeable. Put in new seals, filter screen and gaskets. Keeping the old tranny for parts. Dogone thing weighs a ton and I have to move it around with a chainfall and dolly. At least now I have a valve body, nss, accumulators et al.
Next projects are replacing the power steering seal, Sthe marks her territory wherever parked and checking the fuel pump pressure. Still sputtering at 4200rpm.
 

·
Super Moderator
Joined
·
422 Posts
Discussion Starter · #7 ·
You'll get 'er done no doubt.
I learned stick on our farm tractor and then graduated to a '49 Dodge with fluid drive that was really forgiving.
Taught both daughter and sons stick before they had automatic. Their friends were amazed. Back in the 70's.
Rebuilt two manual transmissions for a '37 and '38 Nash Lafayettes but back then boneyards had lots of salvage. Replaced clutches, Flat head sixes needed rebuilds after 40k. So simple, nothing like today's throw away stuff.
Thanks for all the advice.
Car Tire Wheel Vehicle Land vehicle
 
1 - 5 of 5 Posts
Top