Toyota Celica Forum banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hey guys, I have a '92 Gt that I've spent way too much money on haha, but I bought some 441 feal coilovers with their FABS bump stop and upper radial bearing add on and and all new PU bushings for the front and rear from super pro. But have never done anything like this before. If I were to lower the ride height at all it wouldn't be too much, I installed some 16x7 sparco terra SE wheels, with some Falken Ziex ZE960 A/SP 205 /45 R16 87V XL BSW tires prior to this. I don't want it slammed, just would like to clean it up a little bit.

But the main concern is not doing something that should be done like greasing the bushings or anything else that would need it, or upgrading the control arms, sway bar, tie rods, etc. Any advice guys?
1 - 2 of 2 Posts