Toyota Celica Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
OK, I'm the new guy on the block. Just bought a 1991 Celica GT with 267k. It starts, drives (with issues). I plan on putting it on blocks and going through everything. PO had numerous rigged wires that I want to eliminate, extra buttons etc.
The big problem that shows is that starting out in Drive (auto xmsn) when accelerating there is a hard shake and shutter. Letting off the gas the problem goes away and never shows again until starting out from another stop. I'm planning on changing the front and rear motor mounts. Are there any other mounts that should be looked at while I'm doing this work?
Tks.
 
1 - 1 of 1 Posts
Top