Toyota Celica Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
<font color='#000000'>I have a 1994 Toyota Celica ST and i was woundering if you can put a 3SGTE engine in.  If so what kind of work is needed.  Can it just be bolted in without much modications.  I know the engine is going to cost about 1600 dollars.  Any comments and tips would help greatly before i start this project.  Thanks to all.</font>
 

·
Registered
Joined
·
2,733 Posts
<font color='#000F22'>yeah it goes in there fine, with the engine u also need the tranny, full wiring harness, ecu, intake piping, intercooler, u need to work on ur exsiting exhaust to make it match, you need the mass air meter, ignitor, axles, and some other little odds and ends, to have it done it will cost about 4k someone on the board just had it done with his 6th gen. if you do it urself i would buy a whole clip to make it much easier and that would give u everything you need.</font>
 
1 - 2 of 2 Posts
Top