Toyota Celica Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I’m in the process of changing the transmission filter. The pan is off, the new filter is in and I’m ready to reinstall the pan but can’t find the torque for the pan bolts. Any help is greatly appreciated. Thank you
 

·
Registered
Joined
·
345 Posts
I have the specs if you want but not really necessary. If you install a new gasket just put all the bolts in lightly and then snug them up. not tight. then gradually work your way back and forth in opposite sides until they are all snugged up. then go around the entire pan and tighten them up...not hard, just enough so there is no leakage.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
I have the specs if you want but not really necessary. If you install a new gasket just put all the bolts in lightly and then snug them up. not tight. then gradually work your way back and forth in opposite sides until they are all snugged up. then go around the entire pan and tighten them up...not hard, just enough so there is no leakage.
Ok. Thank you
 
1 - 3 of 3 Posts
Top